Mill Capabilities

OKUMA GENOS M460-VE

• Travel: X: 41.34" Y: 22.05" Z: 18.11
• T-SLOT TABLE 51.18" x 22.05"
• Max table load 1,980 lbs
• 15,000 RPM, 30/25 HP integral motor spindle - standard
• CAT 40 Big Plus V-flange specification
• Spindle jacket cooling system
• Oil air mist spindle bearing lubrication
• Prep for chip conveyor - electrical
• 1,575 IPM, rapid feed X,Y. (.6, .65 G)
• Z-axis rapid & max. feed-rate: 1,259 IPM
• 32 tool ATC magazine 1.2 sec. T-T; 3.5 sec. C-C
• 60 gal roll-away twin 0.5 hp coolant system
• Twin chip channel (insulated) with coil conveyors
• Preparation for 1,000 psi coolant through spindle 
• OSP control system

OKUMA GENOS M560-V

•  Rapid traverse:  X-Y: 40, Z: 32 (X-Y: 1,575, Z: 1,262)
• Travel: X, 30.00, Y 18.11, Z 18.11
• Max load capacity: 700lbs 
• Spindle speed: 12,000 RPMs
• ATC: CAT 40 Big Plus
• Tool Capacity: 32 tools
• OSP Control system

Lathe Turning Capabilities

LB3000 EX II

•  Max Machining Diameter 16.14 Inches
•  Max Machining Length 19.69 Inches
•  Spindle Nose Type JIS A2-6
•  Speed Range 45-5,000
•  Rapid Traverse X - 984, Z - 1,181
•  Standard Power 30/20 HP

Genos L3000-e

  

• Max turning diameter 13.38"
• Max turning length 19.69"
• 12 Position, 0.30 sec, NC V12 turret
• Spindle nose type: JIS A2-8
• Max speed 3,800 
• Power 20 min HP 30
• Power Cont. HP 20
• Rapid Traverse X,Z: 984, 1,181 IPM

Quality Capabilities

Inspection tools

• Tesa-Hite Gauge
• CMM
• Optical Comparator
• Grade A surface plate
• Micrometers up to 24"
• Calipers up to 24"
• Pin gauge sets
• Block Gauge sets
• Dial Bore Gauges